Overview
Pairing your Vanemar Smoke Sensor with the Vanemar Gateway ensures real-time monitoring and instant alerts in the Vanemar App. The process takes just a few minutes and is essential to activate your sensor.
Before You Start
Ensure your Vanemar Gateway is powered on and connected to the internet.
Download and open the Vanemar App on your smartphone.
Remove the battery insulation pull tab from the Smoke Sensor if this is your first setup.
Pairing Vanemar Smoke Sensor Step-by-Step
Open the Vanemar App and go to Devices.
Tap the “+ Add Device” button.
Locate the Networking Button on the sensor.
Use the included reset tool to press and hold the button until the green LED starts flashing rapidly.
4. Follow the on-screen instructions in the app to complete the pairing process.
5. Once pairing is successful, the green LED will remain solid for 3 seconds, then turn off.
Unpairing the Vanemar Smoke Sensor
If you need to remove the sensor from your system:
Press and hold the Networking Button with the reset tool.
2. Continue holding until the green LED flashes slowly (about 5 seconds).
3. The sensor will be successfully disconnected.
Tips for Successful Pairing
Make sure the sensor is within 100 m (328 ft) in open space of the Vanemar Gateway during pairing.
If pairing fails, try resetting the sensor and repeat the steps.
Ensure your smartphone and Gateway are connected to the same network during setup.