Overview
Pairing your Motion Sensor with the Vanemar Gateway is necessary to receive real-time motion alerts on the Vanemar App.
Before You Start
Ensure your Vanemar Gateway is powered on and online.
Open the Vanemar App on your smartphone.
Remove the battery insulation pull tab from the Motion Sensor.
Have the included reset tool ready.
Pairing Vanemar Motion Sensor Step-by-Step
Open the Vanemar App and go to Devices.
Tap the ‘+ Add Device’ button.
3. Locate the networking button on the Motion Sensor.
4. Use the reset tool to press and hold the button until the green LED flashes rapidly.
5. Follow the in-app instructions to complete pairing.
6. Once successful, the LED will remain solid green for 3 seconds before turning off.
Unpairing the Vanemar Motion Sensor
If you need to remove the Motion Sensor from your system:
In the Vanemar App.
Go to Devices.
Select your Motion Sensor.
Tap Remove Device.
Alternatively, press and hold the networking button with the reset tool until the LED flashes slowly green (about 5 seconds). This confirms unpairing.
Tips for Successful Pairing
Place the sensor within 2 meters of the Gateway during initial pairing.
Ensure the battery is installed correctly.
If pairing fails, reset the sensor by pressing and holding the networking button for 10 seconds, then retry.