Overview
Pairing the Vanemar Entry Sensor ensures it can send entry alerts directly to your Vanemar App. This process takes only a few minutes.
Before You Start
Ensure your Vanemar Gateway is powered on and connected to the internet
Download and open the Vanemar App on your smartphone
Remove the battery insulation pull tab from the sensor (if first setup)
Pairing Vanemar Entry Sensor Step-by-Step
Open the Vanemar App and go to Devices.
Tap ‘+ Add Device’.
3. Locate the networking button on the sensor.
4. Using the included reset tool, press and hold the button until the green LED starts flashing rapidly.
5. Follow the on-screen instructions in the app.
6. When paired successfully, the LED will stay solid green for 3 seconds before turning off.
Unpairing the Vanemar Entry Sensor
Press and hold the networking button with the reset tool.
2. Keep holding until the green LED flashes slowly (about 5 seconds).
3. The sensor is now unpaired.
Tips for Successful Pairing
Place the sensor near the Vanemar Gateway during pairing.
Make sure batteries are installed correctly.
If pairing fails, reset and try again.