Skip to main content

Pairing Vanemar Smoke Detector

Step-by-step guide to pair your Vanemar Smoke Detector with the Vanemar Gateway using the Vanemar App.

Overview

Pairing your Vanemar Smoke Detector with the Vanemar Gateway lets you monitor smoke detection on your boat and receive real-time fire alerts in the Vanemar App. Pairing is required to connect the detector to your Vanemar system.

Before You Start

  • Ensure the battery insulation pull tab is removed before pairing.

  • Open the Vanemar App.

Pairing Steps

  1. Tap '+' or 'Add device' in the Devices menu and follow the on-screen instructions.

  2. Press and hold the networking button with the included reset tool until the green LED starts flashing rapidly. The device is now ready to pair.

  3. Once successfully paired, the LED will remain solid green for 3 seconds before turning off.

Removing the battery insulation pull tab from the Vanemar Smoke Detector and selecting “+” on the Devices screen in the Vanemar App to begin pairing.

4. Follow the on-screen instructions in the app to complete the pairing process.

5. Once pairing is successful, the green LED will remain solid for 3 seconds, then turn off.

Unpairing the Vanemar Smoke Sensor

If you need to remove the sensor from your system:

  1. Press and hold the Networking Button with the reset tool.

2. Continue holding until the green LED flashes slowly (about 5 seconds).

3. The sensor will be successfully disconnected.

Tips for Successful Pairing

  • Make sure the sensor is within 100 m (328 ft) in open space of the Vanemar Gateway during pairing.

  • If pairing fails, try resetting the sensor and repeat the steps.

  • Ensure your smartphone and Gateway are connected to the same network during setup.

Did this answer your question?