Before You Start
Securing the Boat: Make sure your boat is stationary and securely moored before beginning installation.
Work Environment: Keep the installation area clear and make sure the mounting surfaces are clean and dry.
ℹ️ Pair your Vanemar Entry Sensor with the Vanemar Gateway before mounting it. Follow the Pairing Vanemar Entry Sensor guide.
Placement Suggestions (Choose an Indoor Location)
Choose an Indoor Location: Choose flat surfaces on the inside of the door, hatch, window, or drawer you want to monitor.
Position the Sensor and Magnet: Place the sensor on the fixed frame and the magnet on the moving part. The magnet can be positioned on either side of the sensor.
Check the Distance: With the door, hatch, window, or drawer closed, the gap between the sensor and magnet must not exceed 15 mm (approximately 0.6 inches).
Leave enough space below the sensor to access the cover release hole and slide the sensor body upward when removing it.
Mounting Steps
Check the positions.
Hold the sensor and magnet in their intended positions. Check that the gap stays within 15 mm when the door, hatch, window, or drawer is closed.Prepare the surfaces.
Clean both mounting surfaces and allow them to dry completely.Attach the sensor.
Peel off the protective backing from the double-sided tape on the sensor cover. Press the sensor firmly onto the fixed frame.Attach the magnet.
Peel off the protective backing from the double-sided tape on the magnet. Press it firmly onto the moving part, maintaining the correct gap.
Check the Installation
Open and close the door, hatch, window, or drawer. Check that both parts remain securely attached and that the Vanemar App shows the correct open or closed status.