Skip to main content

Pairing Vanemar Carbon Monoxide Detector

Step-by-step guide to pair your Vanemar Carbon Monoxide Detector with the Vanemar Gateway using the Vanemar App.

Overview

Pairing your Vanemar Carbon Monoxide Detector with the Vanemar Gateway lets you monitor carbon monoxide levels on your boat and receive real-time alerts in the Vanemar App. Pairing is required to connect the detector to your Vanemar system.


Before You Start

  • Ensure the battery insulation pull tab is removed before pairing.

  • Open the Vanemar App.


Pairing Steps

  1. Tap + or Add device in the Devices menu and follow the on-screen instructions.

    Pulling out the yellow battery pull tab from the Vanemar Carbon Monoxide Detector to power it on and tapping “+” in the Vanemar App’s Devices menu to start pairing.

  2. Press and hold the Networking Button with the included reset tool until the green LED starts flashing rapidly. The device is now ready to pair.

  3. Once successfully paired, the LED will remain solid green for 3 seconds before turning off.

Pressing and holding the Vanemar Carbon Monoxide Detector’s networking button with the reset tool until the green LED flashes rapidly to enter pairing mode, then turns solid green for 3 seconds once paired.


Unpairing the Vanemar Carbon Monoxide Detector

If you need to remove the detector from your system:

  1. Press and hold the Networking Button with the reset tool.

  2. Continue holding until the green LED flashes slowly (about 5 seconds).

  3. The detector will be successfully disconnected.

Pressing and holding the Vanemar Carbon Monoxide Detector’s networking button with the reset tool for about 5 seconds until the green LED flashes slowly to unpair and disconnect the device.


Tips for Successful Pairing

  • Make sure the detector is within 70 m (230 ft) in open space of the Vanemar Gateway during pairing.

  • If pairing fails, try resetting the detector and repeat the steps.

  • Ensure your smartphone and Gateway are connected to the same network during setup.

Did this answer your question?